![]() This binding supports the following thing types: Thing In order for the Pentair EasyTouch controller to receive commands from this binding, you may need to enable "Spa-side" remote on the controller itself. There are no overall binding configurations that need to be set up as all configuration is done at the "Thing" level. The following table shows the available configuration parameters for each thing. ThingĪddress - IP address for the RS-485 adapter - Required. Port - TCP port for the RS-485 adapter - Not Required - default = 10000. ![]() Id - ID to use when communicating on Pentair control bus - default = 34. SerialPort - Serial port for the IT-100s bridge - Required.īaud - Baud rate of the IT-100 bridge - Not Required - default = 9600.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |